I have so many print fails that I couldn’t count on my fingers how much happened during the summer alone!

Common mistakes I would make would be: 

⭐️not drying the filament (humidity)

⭐️not leveling the bed

⭐️using cheap or challenging filaments

⭐️rushing the print (huge mistake)

⭐️part replacements 

It’s very frustrating to watch a print almost done, only for it to fail at the last second or even detach from the bed (or even destroy the parts from heat creep). While it is a waste of filament for each fail,3D printing is addicting, so it’s a great learning opportunity to get better at handling my own machine manually at home. 
For every fail comes a second try at success!

🪦 to all the prints that almost made it 🪦